Port-Mode Mate - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Description
Use the port link-aggregation group command to add the RPR logical interface to the
specified manual aggregation group.
Use the undo port link-aggregation group command to remove the RPR logical
interface from the specified manual aggregation group.
Note that after you assign the RPR logical interface to the aggregation group, the ARP
information of the interface will be erased.
Examples
# Add the RPR logical interface RPRPOS 2/1/1 to aggregation group 1.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] interface RprPos 2/1/1
[H3C-RprPos2/1/1] port link-aggregation group 1

5.1.5 port-mode mate

Syntax
port-mode mate
undo port-mode
View
RPR physical port view
Parameters
None
Description
Use the port-mode mate command to specify the RPR physical port as a mate port.
Use the undo port-mode command to remove the configuration.
By default, no mate port is configured.
Examples
# Specify the RPR physical port RPRPOS 2/1/1.2 as a mate port.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] interface RprPos 2/1/1.2
[H3C-RprPos2/1/1.2] port-mode mate
Chapter 5 Distributed RPR Configuration
5-4
Commands