Rpr Static-Rs - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Description
Use the rpr reversion-mode command to set the protection reversion mode.
Use the undo rpr reversion-mode command to restore the default mode.
The default RPR protection reversion mode is revertive.
Examples
# Set RPR protection reversion mode to non-revertive.
<H3C> system-view
[H3C] interface RprPos2/1/1
[H3C-RprPos2/1/1] rpr reversion-mode non-revertive

1.1.27 rpr static-rs

Syntax
rpr static-rs { mac-address } { ringlet0 | ringlet1 }
undo rpr static-rs [ mac-address ]
View
RPR logical interface view
Parameters
mac-address: MAC address of destination station.
ringlet0: Transports packets to the specified station over Ringlet0.
ringlet1: Transports packets to the specified station over Ringlet1.
Description
Use the rpr static-rs command to configure static ring selection information and force
the RPR ring to transmit packets to the specified station. You can configure them
according to the IP address or MAC address of the destination station.
Use the undo rpr static-rs command to remove the configuration. If no parameter is
selected, the command removes all static configurations.
By default, the static ring selection information is not configured.
Note that two stations' bridge MAC addresses cannot be the same on the ring. Here
both Ringlet0 and Ringlet1 refer to sending sub-rings.
Examples
# Transport data packets to the destination station with MAC address 0016-E266-0101
over ringlet0, and transport data packets to the destination station with MAC address
0016-E266-0202 over ringlet1.
Chapter 1 RPR Port Configuration Commands
1-36