Operation; Acquiring The X-Ray Image; Switching The Unit On And Starting The Software; Switch On The Unit - Dentsply Sirona Orthophos E Ceph Operating Instructions Manual

5 Operation

5.1 Acquiring the X-ray image

A
D D
38
5
Operation
Acquiring the X-ray image
5.1
5.1.1

Switching the unit on and starting the software

5.1.1.1

Switch on the unit

NOTE
Fluctuations in temperature can cause condensation to form in the
unit.
Electrical components are destroyed by short circuits.
➢ Do not switch the unit on until the temperature of the unit has
adapted to the ambient temperature and the condensation has
evaporated. See the chapter on "Technical data".
Malfunctions can occur when the unit is switched on.
A patient positioned in the unit may be injured by moving parts.
➢ Ensure that no patient is positioned in the unit when it is switched
on. In case of an error that requires switching the unit off and
back on again, the patient must be removed from the unit, at the
latest before switching the unit on again!
ü The unit is properly installed.
ü The unit is connected to the mains.
C
1. Turn the main switch (A) to position I.
2. Wait for one minute.
Ä The LED (B) lights up on the Multipad.
Ä The radiation indicator (C) lights up for approx. one second as a
functional check.
Ä Running dots are displayed on the Multipad for several seconds.
B
Ä The values for Program P1 appear on the display. LED D above the
second patient symbol from the left lights up.
Ä The forehead support and temple supports are completely open.
NOTE
The unit must not be switched on/off constantly.
Constant switching on and off reduces the service life of individual
unit components and results in increased power consumption.
➢ After switching the unit off, wait for approx. 60 seconds before
switching it on again.
CAUTION
Dentsply Sirona
Operating Instructions Orthophos E
67 11 001 D3352
D3352.201.12.01.02 03.2019