Saving And Loading The Configuration; Loading Sw Updates - DETEWE OpenCom 130 Mounting And Commissioning Manual

Set IP address
H * 1 8 2 Z
* Z
(www)
Z
(yyy)
Set sub-NET mask
H * 1 8 3 Z
* Z
(www)
Z
(yyy)
Restart
H * 1 8 5
Z
(system PIN)
Saving and Loading the
Configuration
Configurations are saved in a file
archive and can be loaded to the
OpenCom 130 either locally from a
connected configuration PC, or by
remote configuration.
The following configuration and cus-
tomer data can be saved and loaded
again:
Telephony and network
■
parameters
User data
■
Telephone book entries
■
LCR tables
■
For further information, refer to the
online help documentation under
the topic SYS Configuration: Data
backup.
62
Configuring the OpenCom 130
(system PIN)
* Z *
(xxx)
* Z #
(zzz)
(system PIN)
* Z *
(xxx)
* Z #
(zzz)
#

Loading SW Updates

New versions of the system and ter-
minal software can be loaded to the
system.
New software versions of the
OpenCom 130 are loaded from the
configuration PC, which accesses the
Configurator (see the SYS Configu-
ration: Firmware menu). For infor-
mation on connecting a configura-
tion PC, see Brief Guide to Initial
Configuration on page 49.
The terminal software is part of the
OpenCom 130 software and is auto-
matically loaded into the terminals
via the OpenCom 130 if the software
version in the terminal is different
from the terminal software stored in
theOpenCom 130.
Note: If you are operating an PBX
cascade, new system software is au-
tomatically transferred to the slave
system from the master system. If you
are operating an OpenCom 105,
OpenCom 110 or OpenCom 120 slave
system, you require an additional
firmware file with the required ver-
sion ID. In this case, you must import
both firmware files.
For further information, refer to the
online help documentation under
the item SYS Configuration:
Firmware.
Configuration