Saving And Loading The Configuration; Loading Sw Updates; Resetting The System Data - DETEWE OpenCom 510 User Manual

Set IP address
H * 1 8 2 Z
* Z
(www)
Z
(yyy)
Set NET mask
H * 1 8 3 Z
* Z
(www)
Z
(yyy)
Restart
H * 1 8 5
Z
(system PIN)
Saving and Loading the
Configuration
Configurations are saved in a file ar-
chive and can be loaded to the
OpenCom 510 either locally from a
connected configuration PC, or by
remote configuration.
The following configuration and cus-
tomer data can be saved and loaded
again:
Telephony and network parame-
■
ters
User data
■
Telephone book entries
■
LCR tables
■
For further information, refer to the
online help documentation under
the topic SYS Configuration: Data
backup.
84
Configuring the OpenCom 510
(system PIN)
* Z *
(xxx)
* Z #
(zzz)
(system PIN)
* Z *
(xxx)
* Z #
(zzz)
#

Loading SW Updates

New versions of the system and ter-
minal software can be loaded to the
system.
New software versions of the
OpenCom 510 are loaded from the
configuration PC, which accesses the
Configurator (see the SYS Configu-
ration: Firmware menu). For infor-
mation on connecting a configura-
tion PC, see Brief Guide to Initial
Configuration on page 71.
The terminal software is part of the
OpenCom 510 software and is auto-
matically loaded into the terminals
via the OpenCom 510 if the software
version in the terminal is different
from the terminal software stored in
the OpenCom 510.
Note: If you are operating an PBX
cascade, new system software is au-
tomatically transferred to the slave
system from the master system.
For further information, refer to the
online help documentation under
the item SYS Configuration:
Firmware.
Resetting the System
Data
You can restore the factory settings
of the OpenCom 510 in the Configu-
rator.
Configuration