DETEWE OpenCom 130 Mounting And Commissioning Manual page 126

(Configurator, User Manager: User
groups menu).
Check also whether the internal call
number of this telephone has been
configured for outgoing call distri-
bution (Configurator, PBX Configu-
ration: Call Distribution menu).
Question: One of the features
(e.g. call diversion) on one of the
telephones cannot be used even
though the feature has been con-
figured in the Configurator of the
OpenCom 130.
Make sure the user configured for
this telephone belongs to a user
group that has access to this feature
(Configurator, User Manager: User
and User groups menus). Some fea-
tures cannot be used until the sys-
tem PIN is changed.
Question: Nothing is indicated on
the display of one of the connected
ISDN telephones.
You have connected the ISDN tele-
phone to an external S
socket). These ports are intended for
connection to the NTBA only. Con-
nect the telephone to an internal S
port (pressure terminal).
Question: Calls can be made but
not received with one of the ISDN
telephones.
The internal call number that has
been configured for this ISDN tele-
124
Telephony
port (RJ-45
0
0
phone in the Configurator (PBX
Configuration: Ports: S
must also be configured as an MSN
on the ISDN telephone itself. For fur-
ther information, refer to the User
Guide of your ISDN telephone.
Question: It is not possible to con-
figure Call Distribution: Outgoing
for multi-terminal access.
You have configured multi-terminal
access and system access in parallel.
All outgoing calls are therefore es-
tablished via system access, and out-
going call distribution can be config-
ured for system access only
(Configurator, Call Distribution:
Outgoing menu).
A specific MSN can be seized for indi-
vidual calls by means of a code
number procedure. For further infor-
mation, refer to the "OpenCom 100,
Operation on Standard Terminals"
user guide.
Frequently Asked Questions
menu)
0