Dect - DETEWE OpenCom 130 Mounting And Commissioning Manual

DECT

Question: The LED of the RFP 21is
flashing, but none of the cordless
DECT telephones is functioning.
Make sure the terminal setting for
the corresponding U
RFP 21 (Configurator, PBX Configu-
ration: Ports: U menu).
pn
Question: The LED of the RFP 21 is
continuously lit up, but one of the
cordless DECT telephones is indi-
cating "No connection".
You have not configured a port for
this telephone. Configure a port in
the Configurator and start the en-
rolment procedure (PBX Configura-
tion: Ports: DECT-PP menu).
LAN
Question: It is not possible to es-
tablish a network connection with
the OpenCom 130.
Check whether the LEDs for the hub
and the PC's network card are indi-
cating a connection.
Check the LEDs for the LAN functions
of the OpenCom 130. The green LAN
LED at the top indicates whether the
network cable has been properly
Frequently Asked Questions
port is set to
pn
Question: Is it possible to increase
the time for the enrolment proce-
dure?
You must manually enter the IPEI of
the cordless telephone in the Con-
figurator. The enrolment time is
then increased to one hour (PBX
Configuration: Ports: DECT-PP
menu).
Question: Another manufac-
turer's cordless DECT telephone is
not functioning.
Check whether the telephone sup-
ports the DECT GAP standard. In the
Configurator, also make sure GAP is
set for this telephone (PBX Configu-
ration: Ports: DECT-PP menu).
connected. The red LAN LED at the
bottom indicates whether there is
any network traffic on the line.
If you have installed an add-on mod-
ule, also check the LAN LEDs of the
Ethernet switch. The Ethernet line
between the basic module (LAN
port) and the add-on module (LAN1
port) are properly connected if the
125
DECT