Henny Penny KFC Velocity Series Service Manual page 95

6. Locate the 5-pin connector leads, and then connect.
7. Install the control board by performing the installation procedure from
Board Replacement , page
5 5 . . 1 1 2 2 D D r r a a i i n n V V a a l l v v e e a a n n d d A A c c t t u u a a t t o o r r R R e e p p l l a a c c e e m m e e n n t t
B B u u r r n n R R i i s s k k . . U U s s i i n n g g P P P P E E , , r r e e m m o o v v e e h h o o t t o o i i l l f f r r o o m m f f r r y y e e r r b b e e f f o o r r e e
p p e e r r f f o o r r m m i i n n g g p p r r o o c c e e d d u u r r e e o o r r p p e e r r s s o o n n a a l l i i n n j j u u r r y y m m a a y y o o c c c c u u r r . .
S S h h o o c c k k R R i i s s k k . . R R e e m m o o v v e e p p o o w w e e r r f f r r o o m m f f r r y y e e r r b b e e f f o o r r e e p p e e r r f f o o r r m m i i n n g g
p p r r o o c c e e d d u u r r e e o o r r p p e e r r s s o o n n a a l l i i n n j j u u r r y y m m a a y y o o c c c c u u r r . .
T T R R A A I I N N I I N N G G :
To replace either the drain valve or actuator or both, do the following:
5 5 . . 1 1 2 2 . . 1 1 P P r r e e p p a a r r e e t t h h e e F F r r y y e e r r
Access the Filter Menu, refer to .
1 1 ) )
Drain oil from vat (frypot) in to the drain pan, and then remove the drain pan.
2 2 ) )
Close the drain valve, and then exit the menu.
3 3 ) )
With the drain valve closed, remove power from the fryer.
4 4 ) )
Remove the left-side panel.
5 5 ) )
5 5 . . 1 1 2 2 . . 2 2 R R e e m m o o v v e e t t h h e e D D r r a a i i n n V V a a l l v v e e E E x x t t e e n n s s i i o o n n
Disconnect the drain valve harness connector.
1 1 ) )
Remove the drain valve extension from valve by gripping it with hands or
2 2 ) )
channel lock pliers, and then turning the tube 1/8 turn (45°) clockwise, when
viewed from top down.
Pull the drain valve extension down and out of the drain valve.
3 3 ) )
Remove the drain valve extension, and then set aside.
4 4 ) )
3. Use a 3/8 in. socket and extension to
remove the nuts that secure the
transformer to the shroud.
4. Lift up on the transformer and remove it
from the studs.
5. Place the new transformer on to the
studs, and then use a 3/8 in. socket
and extension to secure in place.
63.
5.2 Control
81