Henny Penny KFC Velocity Series Service Manual page 94

5. Place the new transformer on to the studs, and then use a 3/8 in. nut-driver to
secure in place.
6. Reconnect the wires.
7. Install the control board by performing the installation procedure from
Board Replacement , page
5 5 . . 1 1 1 1 C C o o n n t t r r o o l l T T r r a a n n s s f f o o r r m m e e r r R R e e p p l l a a c c e e m m e e n n t t
80
1. Lower the control board by performing
2. Mark the location of the wires, and then
3. Use a 3/8 in. nut-driver to remove the
4. Lift up on the transformer and remove it
63.
D D i i s s c c o o n n n n e e c c t t t t h h e e p p o o w w e e r r o o r r e e l l e e c c t t r r i i c c a a l l s s h h o o c c k k m m a a y y o o c c c c u u r r . .
L L o o w w e e r r i i n n g g t t h h e e c c o o n n t t r r o o l l b b o o a a r r d d e e x x p p o o s s e e s s t t h h e e t t e e c c h h n n i i c c i i a a n n t t o o 2 2 4 4 0 0
V V A A C C e e l l e e c c t t r r i i c c i i t t y y i i n n s s i i d d e e t t h h e e f f r r y y e e r r . .
1. Lower the control board by performing
2. Locate the 5-pin connector leading from
the removal procedure from
Control Board Replacement , page
63.
disconnect.
nuts that secure the transformer to
the shroud.
from the studs.
the removal procedure from
Control Board Replacement , page
63.
the transformer,
disconnect.
5.2
5.2 Control
5.2
and then