Henny Penny KFC Velocity Series Service Manual page 59

Menu Display
Item
(Mod-
e)
T-14 INPUTS-1
T-15 INPUTS-2
T-16 INPUTS-3
T-17 PRESSURE INPUTS
T-17A PUMPING PRESSURE
T-18 OUTPUTS
T-19 DRN VALVE
T-20 SEL VALVE FWD/REV
Function
button to adjust the temperature. To adjust the offset,
press and hold the button next to OFST With the button
held, press the plus or minus button to adjust the
offset.
A H D S F P M shows in the middle display. A - Power
Switch. H - High Limit. D- Drain Switch Jumper. S -
Power Switch. F - Fan Switch Jumper. P - Not in use at
this time. M - Not in use at this time. check - signal pre-
sent. - signal not present.
24dc - 24 DC Supply. Pan - Filter Drain Pan. Lid - Lid
Liner Pin. OK - lid pin is down (not under pressure).
Flashing PR - lid pin is raised (under pressure) check -
active. - inactive.
DTF, HDP, AFR show in the middle display. DTF - Dis-
card Tank Full. check - Tank is full; cannot dispose oil
to tank. HDP - High Dispose Pressure check - Dispose
pumping caused high pressure. AFR - ATO Fill Re-
quest. check - Switch is asking to pump Bulk Supply
Oil to refill the ATO tank.
This section shows the current psi of the lid. If OK is on
the display, the lid is safe to open. Otherwise, PR;
flashes showing lid is under pressure. The bottom dis-
play reads Lid Pin;. If OK is on the display, the lid pin is
down. Other wise, PR flashes showing the pin is raised
(under pressure).
This section shows the current pumping pressure in
psi.
Press the illuminated button next to the feature to test.
Pri - Primary Contactor. Ht - Heat (regulating) Contac-
tor. Pr - Pressure Solenoid. * - On. - - Off.
Be sure drain pan is in place before testing drain valve.
This section tests the drain valve functions. ► - Shows
next to the drain valve current state. Par - Partially
open. Stp - Forced stop. Opn - Fully open. At - Where
the drain valve stopped from 00-20. Max open position
may be as high as 25 or 50. Cls - Fully closed.
This section tests the selector valve rotation position.
Cst - Coast counts how much the motor coasts after
being turned off (11 = typical). Stp - Stop the selector
valve rotation. Fwd - Press to rotate the selector valve
forward. Rev - Press to rotate the selector valve in re-
verse. Enc (encoder) - Shows the position count, 0 to
45