Henny Penny KFC Velocity Series Service Manual page 86

Using a nut driver install 2 inner c-clips in to the retaining rod's retaining
8 8 ) )
grooves.
5 5 . . 5 5 . . 1 1 3 3 I I n n s s t t a a l l l l t t h h e e T T i i l l t t S S t t o o p p
N N O O T T E E :
Install the lid tilt stop, and then test by doing the following:
Ensure the tilt stop is clean prior to installation.
1 1 ) )
Insert the lid tilt stop assembly's retaining rod through the outside of the lid's left
2 2 ) )
lifting arm, tilt stop hole.
Install the inner retaining C-Clip.
3 3 ) )
Test the tilt stop by doing the following:
4 4 ) )
A. Pull on the tilt stop to ensure the C-clip is fully seated.
B. Raise the lid to 45 degrees and setting the tilt stop in to place, then lower. Repeat
several times to ensure the tilt stop does not bind or fail.
5 5 . . 5 5 . . 1 1 4 4 I I n n s s t t a a l l l l t t h h e e S S a a f f e e t t y y L L o o c c k k W W i i r r i i n n g g
N N O O T T E E :
Install the safety lock wiring strain relief assembly. Obtain the spade connectors from
the kit and do the following:
Slide the p-clip, grommet and compression fitting over the safety lock wiring.
1 1 ) )
Using a #2 cross-tip screwdriver, install 1 pan head screw to secure the strain
2 2 ) )
relief wire p-clip to the left inner lid's lifting arm.
Install the grommet with wire into the safety lock wiring cover.
3 3 ) )
Using a #2 cross-tip screwdriver, install the 2 pan head screws securing the
4 4 ) )
safety lock wiring cover to the left lift arm.
Pull the safety lock wiring through the strain relief wiring bracket assembly.
5 5 ) )
Strip the two safety lock wire insulators back 1/4 in to expose the center wire.
6 6 ) )
Crimp two new spade connectors to the two strain relief wires.
7 7 ) )
Apply dielectric grease to the ends of the spade connectors. This ensure
8 8 ) )
connectivity and prevents corrosion.
Connect both spade connectors.
9 9 ) )
Using a 7/9 in wrench, install and snug the strain relief compression fitting.
1 1 0 0 ) )
72
I I n n s s t t a a l l l l a a s s i i n n s s t t r r u u c c t t e e d d , , o o r r t t h h e e l l i i d d c c a a n n f f a a l l l l w w i i t t h h f f o o r r c c e e c c a a u u s s i i n n g g
s s e e r r i i o o u u s s p p e e r r s s o o n n a a l l i i n n j j u u r r y y . .
Navigate to training video timestamp 06:33 - 06:41.
• This procedure only applies to the PXE 100 model fryer.
• Navigate to training video timestamp 06:42 - 07:17.