64
4. Use a 3/8 inch nut-driver or socket and
remove the nut securing the ground
wire to the control board.
5. Remove old control board.
6. Place new control board on to the unit
with the tab inserted in to the slot.
Let the control board rest on the
shroud.
7. Use a 3/8 inch nut-driver or socket and
reconnect the nut securing the
ground wire to the control board.
8. Reconnect all the connectors on the
back of the control board.
9. Use the Phillips head screwdriver to
reinstall the two screws securing the
control board to the front shroud.