Henny Penny KFC Velocity Series Service Manual page 84

Pull out the wiring through the strain relief wiring bracket assembly, and then
7 7 ) )
remove the compression fitting, grommet and p-clip from the safety lock wiring.
5 5 . . 5 5 . . 7 7 R R e e m m o o v v e e t t h h e e T T i i l l t t S S t t o o p p
N N O O T T E E :
The tilt stop, also referred to as the lid kickstand, must be removed so the front shroud
can be removed. Remove the lid tilt stop by doing the following:
Remove the lid tilt stop inner retaining c-clip.
1 1 ) )
Remove the lid tilt stop assembly by pulling the rod out of the outer side of the
2 2 ) )
lid's left lifting arm.
Lay the lid tilt stop assembly aside to a safe and protected space.
3 3 ) )
5 5 . . 5 5 . . 8 8 R R e e m m o o v v e e t t h h e e R R e e t t a a i i n n i i n n g g R R o o d d
N N O O T T E E :
The lid arms must be disconnected from the lid so the front shroud can be fully
removed. Remove the lid by doing the following:
Disengage the lid handle by lifting up on the handle, and then pushing back.
1 1 ) )
Obtain two 4 in x 4 in x 12 in (100 mm x 100 mm x 300 mm) solid blocks.
2 2 ) )
Disengage the front lid hold down, lift the front of the lid up, and then prop up the
3 3 ) )
lid with a block of wood. Force on the lid retaining rod is relieved.
Remove a c-clip and washer from one side (left or right) of the retaining rod.
4 4 ) )
Remove both inner left and right c-clips from the inner left and right lid grooves.
5 5 ) )
Slide the retaining rod out from the lid's arms and the lid lifting arms. Two
6 6 ) )
washers fall off the retaining rod.
Retrieve the two washers and save for reassembly.
7 7 ) )
5 5 . . 5 5 . . 9 9 R R e e m m o o v v e e t t h h e e F F r r o o n n t t S S h h r r o o u u d d
N N O O T T E E :
Lift and pull forward the top, front shroud to remove. Remove the front shroud to
access the Nylatron filler strip channels on the inside by doing the following:
Using a #2 cross-tip screwdriver or electric drill with bit, remove 4 pan head
1 1 ) )
screws from the sides of the front shroud.
Raise the lift arm up and pull the front shroud clear from the arms and wire by
2 2 ) )
doing the following:
A. Press the safety lock wiring against the lid's left lifting arm. This is necessary to
provide clearance for the front shroud removal.
B. Lean the front shroud toward the front of the fryer and pull forward until it is free of the
lid's lifting arms, and then lift up at an angle to remove.
70
Navigate to training video timestamp 02:30 - 02:36 for procedures
specific to this step.
Navigate to training video timestamp 03:05 - 04:04 for procedures
specific to this step.
Navigate to training video timestamp 04:05 - 04:30.