Henny Penny KFC Velocity Series Service Manual page 85

5 5 . . 5 5 . . 1 1 0 0 C C l l e e a a n n t t h h e e N N y y l l a a t t r r o o n n F F i i l l l l e e r r S S t t r r i i p p C C h h a a n n n n e e l l s s
Navigate to training video timestamp 04:31 - 04:52.
N N O O T T E E :
Over time the Nylatron filler strip channels fill with debris and add friction and wear to
the movement of the Nylatron vertical filler strips. Clean the Nylatron strip channels by
doing the following:
Remove the Nylatron vertical filler strips from the channel and discard.
1 1 ) )
Clean the channels using food grade foaming degreaser and a putty knife until
2 2 ) )
clean.
5 5 . . 5 5 . . 1 1 1 1 I I n n s s t t a a l l l l t t h h e e N N e e w w N N y y l l a a t t r r o o n n F F i i l l l l e e r r S S t t r r i i p p
Navigate to training video timestamp 04:53 - 05:54.
N N O O T T E E :
Once both Nylatron filler strip channels are clean, start the reassembly process by
installing the Nylatron vertical filler strips and front shroud by doing the following:
Insert new Nylatron vertical filler strips in to each of the strip channels with the
1 1 ) )
bolt hole that attaches to the counterweight positioned toward the top of the
fryer.
Using an electric drill with a #2 cross-tip bit or a #2 cross-tip screwdriver,
2 2 ) )
remove the 5 pan head screws, and then the center access panel.
Align the two rectangular shaped holes in the Nylatron vertical filler strips, over
3 3 ) )
both of the lid's lifting arms and carefully guide the bottom and then the top of
the shroud in to place.
Gently guide the safety lock wiring through the front shroud opening next to the
4 4 ) )
left lifting arm.
Ensure the lower lip slides into the retention channel.
5 5 ) )
5 5 . . 5 5 . . 1 1 2 2 R R e e c c o o n n n n e e c c t t t t h h e e R R e e t t a a i i n n i i n n g g R R o o d d
Navigate to training video timestamp 05:55 - 06:32.
N N O O T T E E :
Reattach the lid lift arms to the lid by doing the following:
Pull the lid forward to allow the lid lifting arms to clear the lid arms.
1 1 ) )
Apply downward pressure on the lid's lifting arms and align the holes in the lid's
2 2 ) )
arms with the holes in the lid's arms.
Install 1 c-clip and washer on one end of the retaining rod. The c-clip is on the
3 3 ) )
outside.
Slide the opposite end of the retaining rod through the lid's left arm and lifting
4 4 ) )
arm mounting holes.
Stop, install 2 washers on the end of the retaining rod, and then push the
5 5 ) )
retaining rod through the lid's right arm and lifting arm mounting holes.
Using a nut driver install a washer and c-clip on the end of the retaining rod. The
6 6 ) )
c-clip is installed on the outside of the washer.
Push the two inner washers against the inside of the lid's lifting arms.
7 7 ) )
71