Henny Penny KFC Velocity Series Service Manual page 87

5 5 . . 5 5 . . 1 1 5 5 T T e e s s t t t t h h e e S S a a f f e e t t y y L L o o c c k k W W i i r r i i n n g g
• This procedure only applies to the PXE 100 model fryer.
N N O O T T E E :
• Navigate to training video timestamp 07:18 - 07:42.
Test the wiring connection from the control panel by doing the following:
Press the INFO and MAIN MENU buttons simultaneously and =INFO MODE=
1 1 ) )
displays.
Press the top right action button until INPUTS-2 displays at the top. OK displays
2 2 ) )
in the right-side of the lower window.
Raise the safety locking switch. The OK changes to PR.
3 3 ) )
Lower the safety locking switch. The PR changes to OK.
4 4 ) )
• If the test succeeds, continue at
• If the test fails, diagnose and correct before continuing.
5 5 . . 5 5 . . 1 1 6 6 I I n n s s t t a a l l l l t t h h e e C C o o v v e e r r P P a a n n e e l l s s
Navigate to training video timestamp 07:43 - 08:55.
N N O O T T E E :
Install all the cover panels by doing the following:
Ensure the weight carriage lift cables are aligned properly over the pulleys.
1 1 ) )
Remove the solid blocks (lid props), and then lower and lock the lid.
2 2 ) )
Replace the lid's sheet metal cover by aligning the cover's two front pins with the
3 3 ) )
mounting holes in the front of the lower cast lid.
Tilt the sheet metal cover down in to place, aligning the rear screw holes.
4 4 ) )
Using a #2 cross-tip screwdriver, install 3 pan head screws, along the back,
5 5 ) )
securing the sheet metal cover to the lower cast lid.
Using an electric drill with a #2 cross-tip bit or a #2 cross-tip screwdriver, install
6 6 ) )
5 pan head screws to secure the center access panel.
Using an electric drill with a #2 cross-tip bit or a #2 cross-tip screwdriver, install
7 7 ) )
4 pan head screws to secure the sides of the front panel.
P P X X E E 1 1 0 0 0 0 O O n n l l y y : Using a 3/8 in socket and ratchet, install the p-clip holding the
8 8 ) )
condensate line to the back of the front panel.
Remove the 2 bolts from the upper left and right corners of the counterbalance
9 9 ) )
weight carriage assembly.
Install the counterweights into the counterbalance weight carriage assembly.
1 1 0 0 ) )
Using a 7/8 in open end wrench and 2 bolts with lock and flat washers, attach
1 1 1 1 ) )
the bolt hole end of the Nylatron vertical filler strips to the counterbalance weight
carriage assembly.
Using a 3/8 in nut driver, install 6 locking flange nuts to secure the rear panel to
1 1 2 2 ) )
the mounting studs and torque snug.
Place the top access panel over the side panels, ensuring the safety relief valve
1 1 3 3 ) )
assembly is not pinched or hindered.
5.5.16 Install the Cover Panels , page 73.
73