Henny Penny KFC Velocity Series Service Manual page 22

8
frame goes down. The Valve Seat
must be installed with the length of
the rectangular hole in the horizontal
position so it matches the paddle
end of the plunger. Also, there is a
bevel that must
upward so the paddle can be
inserted between the Valve Guide
and Seat.
17. Install the o-ring into the valve body's
o-ring groove.
18. Place the large spring over the plunger
and seat into the valve body.
19. Place the bonnet over the spring and
retainer, plunger and large spring,
and then press the two halves
together.
20. Using a nut driver, install the four 7/16"
hex head screws with captive star
lock washers.
21. Snug the hex head screws with a 7/16"
wrench in a star pattern to evenly
seal the o-ring between both halves
of the valve body.
22. Reinstall the coil over the bonnet with
the conduit on the left side so it does
not interfere with the lid cables.
23. Reinstall the spring washer and top
cap over the coil.
24. Install the clip on top of the cap and
coil.
be positioned