Henny Penny KFC Velocity Series Service Manual page 102

cable in the middle. The lifting cable tension should be tight and the safety cable
tension should be loose enough that when squeezing the cable together, the two
sides can touch. Both cables should be replaced in pairs. The white label denotes the
cable replacement date and should be affixed to the back of the fryer's frame.
88
1. Using a 3/8" nut driver, remove the nuts
securing rear shroud of the fryer and
remove the shroud.
2. Using a Phillips screwdriver, remove
screws securing the top cap and
remove.
3. Lower the lid until it latches, and then
insert two 5/16" carriage bolts, one
through each side of the weight
carriage and in to the frame to
secure the carriage. Ensure the
carriage is level.
N N O O T T E E : Carriage bolt holes are provided in
the frame for securing the carriage.
4. Unscrew and remove both cables from
the weight carriage assembly, and
then the chassis. Remove weights
as needed.
5. Screw a 5/16" lock-nut on each end of
the new cables.
6. Apply blue Loctite thread sealant to the
cable threads.
7. Using an adjustable wrench, screw one
end of each new cable in to the
weight carriage assembly until tight.
8. Using a 1/2" wrench, tighten the lock-
nut against the weight carriage
assembly, securing both cables in to
place.
9. Thread the cables over the pulleys and
down behind the weight assembly.
10. Apply blue Loctite thread sealant to
the cable threads.