D D o o n n o o t t m m o o v v e e t t h h e e f f r r y y e e r r w w i i t t h h h h o o t t o o i i l l i i n n t t h h e e v v a a t t o o r r f f i i l l t t e e r r p p a a n n . .

S S e e v v e e r r e e b b u u r r n n s s c c a a n n r r e e s s u u l l t t f f r r o o m m s s p p l l a a s s h h i i n n g g h h o o t t o o i i l l . .

A multimeter can help you to check the electric components:

• When the manual refers to the circuit being closed, the

NOTICE

• When the manual refers to the circuit being open, the

5 5 . . 2 2 C C o o n n t t r r o o l l B B o o a a r r d d R R e e p p l l a a c c e e m m e e n n t t

D D i i s s c c o o n n n n e e c c t t t t h h e e p p o o w w e e r r o o r r e e l l e e c c t t r r i i c c a a l l s s h h o o c c k k m m a a y y o o c c c c u u r r . .

L L o o w w e e r r i i n n g g t t h h e e c c o o n n t t r r o o l l b b o o a a r r d d e e x x p p o o s s e e s s t t h h e e t t e e c c h h n n i i c c i i a a n n t t o o 2 2 4 4 0 0

V V A A C C e e l l e e c c t t r r i i c c i i t t y y i i n n s s i i d d e e t t h h e e f f r r y y e e r r . .

multimeter should read zero unless otherwise noted.

multimeter should read infinity.

1. Use the Phillips head screwdriver to

2. Press in on the bottom of the board,

3. Disconnect all the connectors on the

remove the two screws securing the

control board to the front shroud.

and rotate the panel down until it

rests on the shroud.

back of the control board.

Table of Contents