Henny Penny KFC Velocity Series Service Manual page 30

wiring. A decal on the inside of the right side panel will help in the wiring of the unit.
Refer to .
1 1 . . 1 1 2 2 . . 2 2 I I n n t t e e r r n n a a t t i i o o n n a a l l R R e e q q u u i i r r e e m m e e n n t t s s
Units being used outside the United States may not be shipped with the power cord
attached to the unit because of the different wiring codes. The fryers are available
from the factory wired for 208, 240, 380 and 415 volts, 3 phase, 50 Hertz service. A
terminal block is mounted inside the fryer for the cable wiring. A decal on the inside of
the right side panel will help in the wiring of the unit. Refer to .
1 1 . . 1 1 3 3 H H i i g g h h L L i i m m i i t t a a n n d d M M o o d d u u l l e e I I n n s s p p e e c c t t i i o o n n
Ensure the high limit and module are undamaged and working within specification by
doing the following:
16
N N e e v v e e r r l l e e a a v v e e a a f f r r y y e e r r w w i i t t h h a a h h i i g g h h l l i i m m i i t t b b y y p p a a s s s s e e d d . . T T h h i i s s c c a a n n
l l e e a a d d t t o o f f i i r r e e , , p p r r o o p p e e r r t t y y d d a a m m a a g g e e , , p p e e r r s s o o n n a a l l i i n n j j u u r r y y o o r r d d e e a a t t h h . .
T T o o a a v v o o i i d d s s e e r r i i o o u u s s p p e e r r s s o o n n a a l l i i n n j j u u r r y y . . U U n n p p l l u u g g f f r r y y e e r r b b e e f f o o r r e e
r r e e m m o o v v i i n n g g t t h h e e l l e e f f t t s s i i d d e e p p a a n n e e l l t t o o p p r r e e v v e e n n t t e e l l e e c c t t r r i i c c a a l l s s h h o o c c k k . .
O O n n l l y y p p e e r r f f o o r r m m t t h h i i s s p p r r o o c c e e d d u u r r e e w w h h e e n n t t h h e e f f r r y y e e r r i i s s c c o o o o l l o o r r
s s e e v v e e r r e e b b u u r r n n s s m m a a y y r r e e s s u u l l t t . .
1. Locate the two high limit control
modules mounted on the left
hand side of the shroud behind
the control.
2. Visually inspect the modules for
cracks, broken
terminals.
3. Visually inspect the high limit
momentary reset switch and
ensure it works.
or loose