Henny Penny KFC Velocity Series Service Manual page 47

1 1 . . 2 2 6 6 I I n n s s p p e e c c t t C C a a m m S S l l i i d d e e F F i i l l l l e e r r s s
T T o o a a v v o o i i d d s s e e r r i i o o u u s s p p e e r r s s o o n n a a l l i i n n j j u u r r y y : :
• D D o o n n o o t t o o p p e e r r a a t t e e w w i i t t h h o o u u t t l l i i d d c c o o v v e e r r i i n n p p l l a a c c e e a a n n d d a a l l l l
• D D o o n n o o t t t t a a m m p p e e r r w w i i t t h h a a n n y y c c o o m m p p o o n n e e n n t t o o f f t t h h e e l l i i d d l l o o c c k k i i n n g g
D D o o n n o o t t a a t t t t e e m m p p t t t t h h i i s s p p r r o o c c e e d d u u r r e e w w h h i i l l e e t t h h e e f f r r y y e e r r i i s s i i n n u u s s e e o o r r
t t h h e e f f r r y y p p o o t t i i s s h h o o t t . . S S e e v v e e r r e e b b u u r r n n s s m m a a y y r r e e s s u u l l t t . . O O n n l l y y p p e e r r f f o o r r m m
t t h h i i s s p p r r o o c c e e d d u u r r e e w w h h e e n n t t h h e e f f r r y y e e r r i i s s c c o o o o l l a a n n d d d d i i s s c c o o n n n n e e c c t t e e d d
f f r r o o m m t t h h e e p p o o w w e e r r s s o o u u r r c c e e . .
Inspect the cam slide fillers on the sides of the lid cover. If either side is damaged or
missing, replace with new cam slide fillers. Why is this important? The cam slide fillers
help minimize the amount of grease laden vapor, breading, dust and debris that can
accumulate on the components under the lid cover.
c c o o m m p p o o n n e e n n t t s s i i n n s s t t a a l l l l e e d d . .
m m e e c c h h a a n n i i s s m m d d u u r r i i n n g g o o p p e e r r a a t t i i o o n n . .
1. Remove old left and right cam slide
2. Install the new left and right cam slide
3. Fit the new cam slide filler around the
4. Reinstall the lid cover, ensure the cam
5. Test that the handle slides forward and
6. Continue to the next inspection or
fillers if necessary by pulling the
remaining pieces out of its channel
and discarding.
fillers by flexing open the slot in the
circular opening.
circular handle cam, ensuring the
edge of the filler is inserted into the
channel.
slide fillers are completely seated on
the inside of the cover.
backwards with little resistance.
Stoppage or resistance
indicates an obstruction present in
the channel, or that the slide is not
seated properly.
reinstall components as applicable.
usually
33