Henny Penny KFC Velocity Series Service Manual page 28

14
1. Press and hold the menu button until
*MAIN* appears on the display.
2. Press the number one product button to
enter the filter menu.
3. Press the right arrow until 4. DRAIN ->
displays.
4. Select 4 4 . . D D R R A A I I N N - - > > , and drain all the oil
in the fry pot into the drain pan.
5. On the inside of the vat, clean off any
build up or debris
temperature probe and level probe.
If a probe is bent or damaged,
replace the probe.
6. Check that each probe is inserted into
the fry pot 3/8" into the oil. If a probe
either extends too far into the oil or is
too shallow, do the following:
a) Remove the left side panel.
b) Adjust the probe to the correct depth by
loosening the ½" compression nut
on the temperature probe.
c) Slide the probe to the correct depth
then tighten the compression nut.
7. Select 5 5 . . F F I I L L L L < < - - . Allow oil to fully fill
the vat. Once filled, cancel the filter
pump motor and exit out of the filter
menu by pressing and holding the
menu button.
8. Continue to the next inspection or
reinstall components as applicable.
from the