Henny Penny KFC Velocity Series Service Manual page 21

9. Remove the valve guide by pulling it
straight up.
10. Slide the valve seat out, and then pull
it out of the valve body.
11. Clean and inspect both of these
components.
N N O O T T E E : The Valve Guide is comprised of
three separate pieces, a seat, spring
and frame. The longer end of the
frame goes down. The Valve Seat
must be installed with the length of
the rectangular hole in the horizontal
position so it matches the paddle
end of the plunger. If a component is
damaged or
specification, replace it.
12. Reinstall the valve seat in the solenoid
valve body.
N N O O T T E E : Ensure the rectangle opening is
oriented horizontally in the valve
body. This ensures the beveled lip is
pointing up, which is necessary
when inserting the plunger.
13. Assemble the valve guide (frame +
seat + seat) by inserting the longer
end into the valve body, keeping the
seat compressed so it slides past
the valve seat.
14. Press the plunger's paddle end down
between valve guide and valve seat.
15. Ensure the plunger slides up and
down freely.
16. Insert the small spring and retainer
into the top of the plunger.
N N O O T T E E : The Valve Guide is comprised of
three separate pieces, a seat, spring
and frame. The longer end of the
worn beyond
7