Henny Penny KFC Velocity Series Service Manual page 32

1 1 . . 1 1 5 5 D D r r a a i i n n P P a a n n C C o o m m p p o o n n e e n n t t I I n n s s p p e e c c t t i i o o n n
T T R R A A I I N N I I N N G G :
Ensure the drain pan components are undamaged and working within specification by
doing the following:
18
1 1 . . Attach an amp meter (amp clamp
2 2 . . Connect power to the fryer, turn on
3 3 . . Repeat steps 1 – 2 for each of the
4 4 . . Repeat steps 1 – 2 for each of the
5 5 . . Add the amp reading from all six
6 6 . . If this figure is lower than what is on
7 7 . . Continue to the next inspection or
D D o o n n o o t t a a t t t t e e m m p p t t t t h h i i s s i i n n s s p p e e c c t t i i o o n n u u n n t t i i l l t t h h e e f f r r y y e e r r h h a a s s h h a a d d t t i i m m e e
t t o o c c o o o o l l , , o o t t h h e e r r w w i i s s e e s s e e v v e e r r e e b b u u r r n n s s m m a a y y r r e e s s u u l l t t . . O O n n l l y y p p e e r r f f o o r r m m
t t h h i i s s p p r r o o c c e e d d u u r r e e w w h h e e n n t t h h e e d d r r a a i i n n p p a a n n i i s s c c o o o o l l . .
Watch how to disassemble and reassemble the Drain Pan.
style) to one of the upper heating
element's wires.
the controls, and then set to call for
heat. Once the fryer calls for heat,
measure and note amp draw.
other upper heating element's wires
connected to the upper heater. The
amp draw should be close to the
same for each of the wires.
lower heating element's
connected to the lower heater. The
amp draw should be close to the
same for each of the wires.
wires together, and then divide by
1.73. The figure should equal what
is listed on the data label.
the data label, then troubleshoot to
find the issue with either incoming
power, the contactor or the heater
assemblies.
reinstall components as applicable.
wires