Tyre Monitoring System - Seat Toledo 2019 Owner's Manual

CAUTION
Follow the instructions given on the tempo-
rary spare wheel label.
Note
The tyre pressure of the spare wheel must
always correspond to the highest pressure
prescribed for the model of vehicle in ques-
tion.

Tyre monitoring system

Control lamp
 It lights up
The tyre pressure of a wheel is much lower than the
›››
value set by the driver
 Flashes
Fault in the tyre pressure gauge. Contact a special-
ised service to have it fixed.
WARNING
If the warning lamp
●

down immediately and avoid any severe
braking or steering manoeuvres. Stop and
check the tyres and their pressure as soon
as possible.
260
Under certain conditions (e.g. sporty
●
driving style, driving on loose surfaces or in
winter) the warning lamp
while to light up or may remain switched
off.
Note
If the battery is disconnected the warning
lamp
switched on. This warning lamp must switch
off after covering a short distance.
Tyre pressure*
The tyre pressure monitoring system uses ABS
sensors to compare the revolutions and the
circumference of each wheel. Should the cir-
cumference of any wheel change, the warn-
ing lamp
.
will light up and an audible warning will be
heard.
Tyre circumference may change if:
Tyre pressure is too low
●
Tyre structure is damaged
●
Vehicle load not evenly distributed
●
lights up, slow
wheels on one axle are subjected to great-
●
er load, (e.g. driving with trailer, uphill, down-
hill);
Snow chains are fitted
●
The temporary spare wheel is fitted
●
Practical tips
may take a

lights up when the ignition is

on the general instrument panel

One wheel on the axle has been changed
●
Basic system settings
Should the tyre pressure change or if one or
more wheels are changed or the position of
the wheel on the vehicle is changed, e.g.
changing round the front and rear wheels, or
where a warning lamp lights up when driving,
the system must be adjusted as follows:
Inflate all tyres to the prescribed pressures
●
›››
page 256.
Switch the ignition on.
●
Store the new tyre pressure in the Easy
●
Connect system with the button and the

›››

function button
SETTINGS
In vehicles without a radio: press and hold
●
down the button , with the ignition on,

until an acoustic signal is heard.
WARNING
Despite the tyre pressure monitoring sys-
tem, the driver remains responsible for
maintaining the correct tyre pressure. You
must therefore check the tyre pressure of-
ten.
Note
The tyre pressure monitoring system is
●
not a replacement for regularly checking
the tyre pressure, as it is unable to recog-
nise an even drop in pressure.
page 24.