Remove the bulb holder.
Fig. 105
The rear lid must be open to change the
bulbs.
You can access the bulb holder for the inner
tail lights through the inside of the rear lid.
Check which of the bulbs is defective.
–
Open the cover to access the lights, turning
–
it by hand in the direction indicated by the
arrows.
Access the lights by disconnecting the con-
–
›››
nector
Fig. 105
and unscrewing
1
Fuses and bulbs
›››
the bulb holder
Fig. 105
to lose the bulb holder retaining screw.
›››
Change the bulbs
page
93.
–
Changing bulbs
Position of the bulbs in the bulb hold-
Fig. 106
er
The bulbs are secured with a bayonet fasten-
er. The table below gives an overview of the
›››
bulbs
table on page
93.
Lightly press the defective bulb into the
–
bulb holder, then turn it anti-clockwise and
remove it.
Fit the new bulb, pressing it into the bulb
–
holder and turn it clockwise as far as it will
go.
Use a cloth to remove any fingerprints from
–
the glass part of the bulb.
. Take care not
Check that the new bulb works properly.
–
Re-install the bulb holder
–
Screw in the bulb holder.
–
Position of the bulbs
›››
Fig. 106
A
B
C
Note
One of the two sides may not be fitted with
a fog light, depending on the country and
type of driving. In this case, the hole for the
light is covered.
Fitting the bulb-holder
Position the bulb holder on the tail light and
–
align it so that it is securely seated.
Screw in the bulb holder using the corre-
–
sponding screw.
Make sure the connector is correctly in
–
place.
Close the inner trim cover.
–
›››
page
93.
Bulb function
Reversing lights: P21W
Side lights: R5W LL
Fog lights: P21W
»
93