Seat Toledo 2019 Owner's Manual page 220

On releasing rocker switch
current speed is stored and will remain con-
stant without having to press the accelerator
pedal.
Increasing speed by pressing the acceler-
ator pedal
Press the accelerator to increase the speed
●
of the vehicle.
Release the accelerator and the previously
●
programmed speed will be resumed.
If, when pressing the accelerator, the vehicle
exceeds the programmed speed by more
than 10 km/h (6 mph) for more than 3 mi-
nutes, the set speed will be deleted. The
speed will have to be stored again.
Increasing speed by pressing switch
Press rocker switch
● 2
›››
page 217 in position

If the button is held down in the
●
the speed increases continuously. Release
the switch when the required speed is
reached. The speed is stored.
Setting a lower speed
The set speed can be reduced by pressing
●
››› ›››
switch Fig. 222
2
If the button is held down in the
●
the speed decreases continuously. Release
218
from , the the switch when the required speed is
2 
reached. The speed is stored.
On releasing the switch at speeds of less
●
than 30 km/h (19 mph), no speed will be set
and the memory will be deleted. The vehicle
must be moving at a speed of over 30 km/h
(19 mph) and switch
for it to be set.
The speed can be reduced by pressing the
brake pedal, which temporarily switches off
the cruise control.
Temporary deactivation of cruise control
Cruise control is switched off temporarily
by pressing switch
›››
page 217
or clutch pedal.
2
The set speed is stored.
›››
Fig. 222
To recover the set speed, briefly press the
.
button
position,

leased the brake pedal.
Turning off the cruise control system
Move knob
●
the

WARNING
page 217 in .

For safety reasons the cruise control sys-
●
position,

tem must not be used in dense traffic or
where roads conditions are poor (e.g. due
Driving
pressed again to
2
›››
Fig. 222
1
in or by pressing the brake

in position once you have re-
2 
››› ›››
Fig. 222 page 217
1
position.
to ice, aquaplaning, loose grit, snow) - Risk
of accident!
The programmed speed can only be re-
●
established if it is not too high for current
traffic conditions.
Always switch the cruise control system
●

off after using it in order to avoid involunta-
ry use.
CAUTION
The cruise control cannot maintain a
●
constant speed when the vehicle is moving
downhill. The vehicle tends to accelerate
under its own weight. Therefore, shift down
or use the brake pedal in good time to slow
the vehicle.
Note
In vehicles with an automatic gearbox,
●
the cruise control system cannot be
switched on if the selector lever is in posi-
tion P, N or R.
In vehicles with a manual gearbox, the
●
cruise control cannot be switched on if first
gear or reverse gear is engaged.
to