Seat Toledo 2019 Owner's Manual page 154

Press the button
●

13
›››
Adjust vents 3 and 4
●
the air flow is directed slightly upwards.
Change between degrees Centigrade and
degrees Fahrenheit
›››
Keep the and
 
down for 2 seconds at the same time. The
data is displayed on the screen in the units
required.
Note
A visit to the specialised service once a
●
year is recommended to clean the Clima-
tronic system.
The interior temperature sensor
●
›››
Fig. 170 is at the bottom. Do not cover it
with stickers or the like, as this could have a
negative effect on Climatronic operations.
Automatic mode
Automatic mode is used to maintain a con-
stant temperature and demist the windows
inside the vehicle.
Switching on automatic mode
Set a interior temperature between +16°C
●
(+64°F) and +29°C (+84°F).
›››
Adjust vents 3 page 147
●
the air flow is directed slightly upwards.
152
›››
Fig. 170. Press the button
●
is displayed on the screen.
AUTO
page 147 so that
Automatic mode is switched off by pressing
the air distribution buttons or increasing or
decreasing the blower speed. However, the
temperature remains regulated.
Fig. 170 buttons held
Adjusting the temperature
When you switch on the ignition, control
●
›››
Fig. 170
terior temperature.
It is possible to select interior temperatures
from +16°C (+64°F) to +29°C (+84°F). In this
11
range the temperature is regulated automati-
cally. If a temperature below +16°C (+64°F) is
selected, "LO" is displayed on the screen. If a
temperature above +29°C (+84°F) is selec-
ted, "HI" is displayed on the screen. At both
extremes, Climatronic works at maximum
cooling or heating power, respectively. The
temperature is not regulated.
In the event of prolonged, irregular distribu-
tion of the air flow from the outlets (particu-
larly the footwells) and significant differences
in temperature, e.g. on leaving the vehicle,
sensitive people may catch cold.
and 4 so that
Operation
›››
Fig. 170, and

13
can be used to set the required in-
Air recirculation
Air recirculation prevents unpleasant smells,
e.g. when passing through a tunnel or in
queuing traffic, from entering the interior.
Switching on air recirculation mode
Press the button
● 
17
symbol is displayed on the screen.

Switching off air recirculation mode
1
Press the button
●

17
symbol disappears from the screen.

WARNING
Read and observe the safety warnings
in General notes on page
Note
If air recirculation mode remains on for 15
minutes, the symbol will start to flash on

the screen to indicate prolonged air recir-
culation. If air recirculation is not switched
off, the symbol will continue to flash for
about 5 minutes.
Blower selection
Climatronic automatically regulates blower
speed according to the interior temperature.
›››
Fig. 170 and the
›››
Fig. 170 and the
›››
146.