Seat Toledo 2019 Owner's Manual page 76

 
It lights up on the dash panel
Front passenger front airbag disabled.
Check whether the airbag should remain disabled
The control lamp monitors all airbags and
seat belt tensioners in the vehicle, including
control units and wiring connections.
Monitoring of airbag and belt tensioner
system
Both the airbag and belt tensioner systems
operation is constantly monitored electroni-
cally. Each time the ignition is switched on,
the control lamp illuminates for several

seconds (self-diagnosis) and the instrument
panel display* shows AIRBAG/TENSIONER.
The system must be checked when the
control lamp :

does not light up when the ignition is
●
switched on,
turns off after 4 seconds after the ignition is
●
switched on,
turns off and then lights up again after the
●
ignition is switched on,
illuminates or flashes while the vehicle is
●
moving.
In the event of a malfunction, the warning
lamp stays on continuously. In addition, de-
pending on the malfunction, a fault message
appears on the instrument panel display for
74
Safety
approximately 10 seconds and a short audi-
ble warning is given. In this event, you should
have a specialised workshop check the sys-
tem immediately.
The airbag system availability is controlled
electronically, regardless of whether an air-
bag is disabled.
If the front airbag, side airbag, head pro-
tection airbag or the belt tensioner are
disabled using the diagnostics system:
After switching on the ignition, the
●
ing lamp illuminates for about 4 seconds and
flashes for another 12 seconds.
The informative display indicates:
Airbag/belt tensioner disabled!
If the front passenger airbag has been dis-
abled with the airbag switch located in the
storage compartment side:
When the ignition is turned on, the
●
ing lamp illuminates for about 4 seconds.
The airbag is disabled, signalled with the
●
warning lamp which lights up with the
 
word placed in the cen-
    
›››
tre part of the dash panel Fig. 82
›››
page 73.
WARNING
If there is a malfunction, the airbag and
●
belt tensioner system cannot properly per-
form its protective function.
If a malfunction occurs, have the system
●
checked immediately by a specialised
workshop. Otherwise, in the event of an ac-
cident, the airbag system and belt tension-
ers may not be triggered, or may not be
triggered correctly.
warn-

warn-
