Controls For The Windows - Seat Toledo 2019 Owner's Manual

Table of Contents

Advertisement

Controls for the windows

Operation of the electric windows
Detail of the driver door: controls for
Fig. 128
the windows.
Read the additional information carefully
›››
page 14
The electric window opening and closing
system only works when the ignition is switch-
ed on.
Opening
Press gently on the respective button on
the door to open the window. The process
will stop when the button is released.
The driver door window can also be auto-
matically opened by pressing the button as
far as it will go (fully open). Press the button
again to immediately stop it.
Opening and closing
Closing
Press the respective button gently to close
the window. The process will stop when the
button is released.
Safety button
›››
Press the safety button
Fig. 128
activate the controls on the rear doors. Press-
ing the safety button
again will reactivate
5
the controls on the rear doors.
If the rear door controls are deactivated, the
warning lamp
on the safety button
light up.
WARNING
When locking the vehicle from the out-
side, make sure that nobody is inside the
vehicle, as the windows cannot be opened
from the inside in an emergency.
For safety reasons, use the safety button
that deactivates the window switches
5
on the rear doors when children are travel-
ling in the rear seats.
CAUTION
Keep the windows clean to ensure the
system operates correctly.
›››
Defrost
page 269
any frozen windows
before using the electric windows. Other-
wise you run the risk of damaging the elec-
tric window riser mechanism.
Always make sure all of the windows are
closed on leaving the locked vehicle.
Note
The vehicle heating and ventilation sys-
tem should be used to ventilate the interior
to de-
5
while driving. Leaving the windows open
could allow dust and other dirt to enter the
vehicle and cause unpleasant noises at
certain speeds.
Do not leave the side windows open at
will
high speeds, as this will overly increase
5
fuel consumption.
Note
The electric window opening mechanism is
equipped with a thermostat switch. This
may overheat if the window is opened and
closed repeatedly. This causes the window
to lock temporarily. Once the thermostat
switch has cooled down, the window can
be operated once again.
Roll-back function on the electric
windows
The electric windows are equipped with a
roll-back system that reduces risk of injury
when closing windows.
»
119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents