Seat Toledo 2019 Owner's Manual page 101

Do not operate the instrument panel con-
●
trols when driving.
CAUTION
To prevent damage to the engine, the rev
●
counter needle should only remain in the
red zone for a short period of time.
When the engine is cold, avoid high revs
●
and heavy acceleration and do not make
the engine work hard.
For the sake of the environment
Changing up a gear in time reduces fuel
consumption and noise.
Revolution counter
The rev counter indicates the number of en-
›››
gine revolutions per minute Fig. 111
Together with the gear-change indicator, the
rev counter offers you the possibility of using
the engine of your vehicle at a suitable
speed.
The start of the red zone on the dial indicates
the maximum engine speed which may be
used briefly when the engine is warm and af-
ter it has been run in properly. Before reach-
ing this range, you should change to a higher
gear for vehicles with a manual gearbox or
for automatic gearboxes put the selector lev-
Instruments and warning lamps
er in "D" or take your foot off the accelerator
pedal.
We recommend that you avoid high revs and
that you follow the recommendations on the
gear-change indicator. Consult the addition-
›››
al information in page
CAUTION
Never allow the rev counter needle
›››
Fig. 111 to go into the red zone on the
scale for more than a very brief period, oth-
erwise there is a risk of engine damage.
For the sake of the environment
Changing up a gear early will help you to
save fuel and minimise emissions and en-
gine noise.
Indications on the display
.
1
A variety of information can be viewed on the
instrument panel display
pending on the vehicle equipment:
Bonnet, rear lid and doors open
●
›››

page 31.
Information and warning texts.
●
Mileage.
●
Time.
●
Navigation instructions.
●
Outside temperature.
●
Compass.
●
Shift lever position
●
Recommended gear (manual gearbox)
●
›››
page
208.
Multifunction display (MFD) and menus with
●
different setting options
Service interval display
●
1
Second speed display
●
Speed warning function
●
Start-Stop system status display
●
›››
page
Low consumption driving status
●
›››
page 100
Identifying letters on engine (LDM)
●
›››
page
Distance travelled
The odometer registers the total distance
travelled by the car.
›››
Fig. 111 de-
3
The odometer ( trip ) shows the distance
travelled since the last odometer reset. The
last digit of the trip recorder indicates distan-
ces of 100 metres or one tenths of a mile.
Briefly press the button
●
set the trip recorder to 0.
Keep the button
●
seconds and the previous value will be dis-
played.
›››
page 205.
208.
›››
 page 27.
›››

page 33.
›››
page 100.
›››
 page 32.
215.

100.
›››
Fig. 111 to re-
4
pressed for about 3
4
»
99