Seat Toledo 2019 Owner's Manual page 116

Keyless Access is a key-free locking and igni-
tion system to unlock and lock the vehicle
without actively using its key. For this, all that
is required is to have a valid vehicle key near
›››
Fig. 123 the vehicle and one of the sensor
surfaces on the door handles to be touched
›››
Fig. 124.
General information
If a valid key is in the proximity of the car
›››
Fig. 123, the Keyless Access locking and
starting system gives the key entry as soon as
one of the sensor surfaces on the door han-
dles is touched or the push button on the
boot hatch is operated. The following fea-
tures are then available without having to use
the vehicle key actively:
Keyless-Entry: unlocking of the vehicle with
●
the handles on the four doors or the button
located on the boot hatch.
Keyless-Go: engine ignition and driving. For
●
this to occur, there has to be a valid key inside
the vehicle and the ignition push button
›››
needs to be pressed page
Keyless-Exit: unlocking of the vehicle with
●
one of the four door handle.
The central locking and locking systems op-
erate in the same way as a normal locking
and unlocking system. Only the controls
change.
114
Unlocking the vehicle is confirmed with a
double flash of the indicator lights; locking by
a single flash.
The vehicle will lock again after a few sec-
onds if you unlock the vehicle but fail to open
any door or boot hatch.
Unlocking and opening the doors (Key-
less-Entry)
Grip the door handle. In doing this, the sen-
●
sor surface
dle is touched and the vehicle unlocks.
Open the door.
●
In vehicles without safety system "Safe":
closing and locking the doors (Keyless-Ex-
it)
Switch the ignition off.
●
Close the driver's door.
●
Touch (once) the sensor surface
●
on the door handle. The door that is used
must be closed.
197..
In vehicles with safety system "Safe":
closing and locking the doors (Keyless-Ex-
it)
Switch the ignition off.
●
Close the driver's door.
●
Touch (once) the sensor surface
●
on the door handle. The vehicle locks with the
Operation
›››
Fig. 124 (arrow) on the han-
A
(arrow)
B
(arrow)
B
›››
"Safe" security system page
that is used must be closed.
Touch (twice) the sensor surface
●
on the door handle to lock the vehicle without
›››
the "Safe" security system page
Unlocking and locking the boot hatch
When the vehicle is locked, the hatch auto-
matically unlocks on opening if
there is a valid vehicle key in the proximity.
Open or close the hatch normally
›››
page 117.
After closing, the hatch locks automatically.
In the following instances, the rear lid does
not lock automatically after closing:
If the entire vehicle is unlocked.
●
If the key used last is inside the vehicle. All
●
vehicle indicator lights flash four times. The
vehicle will lock again after a few seconds if
no door or boot hatch are opened.
Locking the vehicle with a second key
If there is a vehicle key inside the vehicle and
it is locked from the outside with a second ve-
hicle key, the key inside the vehicle is blocked
›››
for engine ignition page 196. In order to
enable engine ignition, the button on the

key inside the vehicle needs to be pressed
›››
page 108.
112. The door
(arrow)
B
112.
›››
Fig. 123