Seat Toledo 2019 Owner's Manual page 239

Verify the correct placement of the ball-
–
›››
headed bar page 237.
WARNING
Do not hold the manual regulator with
●
your hand when fitting the ball-headed bar
since you could sustain injuries to your fin-
gers.
When mounting the ball-headed bar, al-
●
ways lock it with a key and remove the key
from the slot.
The ball-headed bar must not be in the
●
service position with the key in the key slot.
If the ball-headed bar is not placed in the
●
service position you will not be able to
place it in the clamping bush.
CAUTION
When removing the key, always place the
cover over the key slot of the manual regu-
lator to prevent dirt from entering.
Note
Once removed, place the clamping bush
cap in an appropriate location in the boot.
Towing bracket device
Verification of correct placement
Correct placement of the ball-head-
Fig. 238
ed bar.
Before using the ball-headed bar, ensure it is
correctly fitted.
Ensure that:
The ball-headed bar does not come out of
●
the clamping bush in a "jerky" manner.
›››
The red mark Fig. 238 on the manual
●
A
regulator signals toward the white mark on
the ball-headed bar.
The manual regulator is adjusted to the
●
ball-headed bar, leaving no space between
them.
The regulator is locked and the key has
●
been removed.
Cover has been placed over the manual
●
B
regulator lock.
WARNING
Only use the towing bracket device when
the ball-headed bar is properly fitted!
237