Seat Toledo 2019 Owner's Manual page 103

WARNING
›››
Observe the safety warnings
trol and warning lamps on page
WARNING
Even though outside temperatures are
above freezing, some roads and bridges
may be icy.
At outside temperatures above +4°C
●
(+39°F), even when the "ice crystal sym-
bol" is not visible, there may still be patch-
es of ice on the road.
The outside temperature sensor takes a
●
guideline measurement.
Note
Different versions of the instrument panel
●
are available and therefore the versions
and instructions on the display may vary. In
the case of displays without warning or in-
formation texts, faults are indicated exclu-
sively by the warning lamps.
Depending on the equipment, some set-
●
tings and instructions can also be carried
out in the Easy Connect system.
When several warnings are active at the
●
same time, the symbols are shown succes-
sively for a few seconds and will stay on
until the fault is rectified.
Instruments and warning lamps
Odometer
in Con-
103.
Instrument panel: odometer and reset
Fig. 112
button.
The distance covered is displayed in "kilome-
tres" or miles "m". It is possible to change the
measurement units (kilometres "km"/miles
"m") in the radio/Easy Connect*
›››
 page 24.
Odometer/trip recorder
The odometer shows the total distance cov-
ered by the vehicle.
The trip recorder shows the distance that has
been travelled since it was last reset. It is used
to measure short trips. The last digit of the trip
recorder indicates distances of 100 metres or
tenths of a mile.
The trip recorder can be set to zero by press-
›››
ing
0.0/SET
Fig. 112.
Fault display
If there is a fault in the instrument panel, the
letters DEF will appear in the trip recorder dis-
play. Have the fault repaired immediately, as
far as is possible.
Coolant temperature gauge
Instrument panel: coolant tempera-
Fig. 113
ture gauge
For vehicles with no coolant temperature
gauge, a control lamp appears when the

›››
coolant temperatures is high
›››
Please note .
The coolant temperature gauge only works
when the ignition is switched on
order to avoid engine damage, please read
the following notes for the different tempera-
ture ranges.
page 248.
›››
Fig. 113. In
»
101