Central Locking System - Seat Toledo 2019 Owner's Manual

Replacing the battery in the remote
control key
Vehicle key: opening the battery com-
Fig. 119
partment.
Vehicle key: removing the battery.
Fig. 120
SEAT recommends you ask a specialised
workshop to replace the battery.
1) Valid for vehicles with a keyless fuel tank cap.
110
Operation
The battery is located to the rear of the vehi-
cle key, under a cover.
Changing the battery
Unfold the vehicle key shaft.
●
Remove the cover from the back of the ve-
●
›››
hicle key Fig. 119 in the direction of the ar-
›››
row .
Extract the battery from the compartment
●
›››
using a suitable thin object Fig.
Place the new battery in the compartment
●
›››
as shown Fig. 120, pressing in the opposite
direction to that shown by the arrow
›››
Fit the cover as shown Fig.
●
it onto the vehicle key casing in the opposite
direction to that shown by the arrow until it
clicks into place.
CAUTION
If the battery is not changed correctly,
●
the vehicle key may be damaged.
Use of unsuitable batteries may damage
●
the vehicle key. For this reason, always re-
place the dead battery with another of the
same voltage, size and specifications.
When fitting the battery, check that the
●
polarity is correct.
For the sake of the environment
Please dispose of your used batteries cor-
rectly and with respect for the environ-
ment.
Note
If it is not possible to unlock or lock the ve-
hicle with the remote control key once the
battery has been replaced, it will need to
120.
be re-synchronised
›››
.

Central locking system

119, pressing
General notes
All of the doors, the rear lid and the fuel cap
1)
flap will unlock at the same time when the
central locking system is used.
Warning lamp on the driver door
Once the doors are locked, the warning lamp
will flash quickly for 2 seconds and then at a
slower rate.
If the vehicle is locked with Safe lock engag-
›››
ed page 112, the warning lamp on the
›››
page 109.