Seat Toledo 2019 Owner's Manual page 124

your vehicle does not dazzle others, par-
●
ticularly oncoming traffic;
the range of the headlights is sufficient
●
for safe driving.
Note
Make sure you set the range of the main
lights when the dipped beam headlights
are switched on.
Daytime running lights
Daytime running lights are signalling devices
for improving road safety. The lights are built
into the headlights and come on each time
the ignition is turned on if the light switch is in
›››
position or Fig. 129. It is automatical-
 
ly switched off when the side lights are turned
on.
Switching the daytime driving lights on
Remove the key from the ignition, move the
●
turn signal lever upward (right turn signal),
press it back to flash position and hold it
there.
Insert the key and switch on the ignition,
●
holding it in this position for 3 seconds. Then,
switch off the ignition. The daytime running
light is now activated and the corresponding
lights can come on.
122
Operation
Switching the daytime running light off
Remove the key from the ignition, press the
●
turn signal lever down (left turn signal), press
it back to flash position and hold it here.
Insert the key and switch on the ignition,
●
holding it in this position for 3 seconds. Then,
switch off the ignition. The daytime running
light is now deactivated and the correspond-
ing lights cannot come on.
OR: activate and deactivate the daytime
lights using the Easy Connect system
›››

page 24.
Automatic control of the dipped beam in
combination with the daytime running
lights
If the dipped beam control and the daytime
running lights are activated at the same time,
the dipped beams and the instrument panel
lighting will automatically come on as re-
quired (e.g. when entering a tunnel) and the
daytime running lights will switch off. When
the automatic dipped beam control switches
off the dipped beams (e.g. when coming out
of a tunnel), the daytime running lights come
back on.
WARNING
On vehicles with rear lights with bulbs,
when activating the daytime running light
the rear lights are not switched on. A vehi-
cle which does not have the rear lights on
may not be visible to other drivers in the
darkness, in the case of heavy rain or in
conditions of poor visibility.
Note
Please observe any relevant legal require-
ments which may apply in your country.
Turn signal and main beam head-
lights lever
Turn signal and main beam lever.
Fig. 131
The turn signal and main beam lever also op-
erates the parking lights and the headlight
flasher.
Right and left-hand turn signal

›››
Move the lever Fig. 131 up
●
Keep the lever held down at the point of re-
●
sistance for the turn signals to flash for as

or down .
1 2