Seat Toledo 2019 Owner's Manual page 93

Check which of the bulbs is defective.
Open the luggage compartment to access
–
the rainduct area.
Take the screwdriver or a Torx 20 key (T20)
–
from the vehicle tool kit and loosen (turning
anti-clockwise) and remove the two retain-
ing screws that secure the front of the light
›››
Fig. 98 , taking care not to lose them.
1
Pull the rear light unit backward (
–
) to remove the light from its housing.
2
Removing the bulb holder
Light connector at the rear of the rear
Fig. 99
light unit.
Fuses and bulbs
›››
Fig. 98
Retaining screws on reverse side of
Fig. 100
rear light unit.
Disconnect the light connector
–
›››
Fig. 99 by moving its side levers (arrows)
and pulling the connector outwards.
Place the light on a level, horizontal surface
–
on top of a soft cloth so as not to scratch
the outer glass.
Unscrew the four retaining screws from the
–
bulb holder anti-clockwise using a screw-
driver or a Torx 20 key (T20) from the vehi-
›››
cle tool kit Fig.
the bulb holder retaining screws.
A
The bulbs are secured with a bayonet fasten-
er. The table below gives an overview of the
bulb positions.
–
–
100. Take care not to lose
–
–
–
–
Changing bulbs
Position of the bulbs in the bulb holder
Fig. 101
Lightly press the defective bulb into the
bulb holder, then turn it anti-clockwise and
remove it.
Fit the new bulb, pressing it into the bulb
holder and turn it clockwise as far as it will
go.
Use a cloth to remove any fingerprints from
the glass part of the bulb.
Check that the new bulb works properly.
Replace the bulb holder.
Screw in the bulb holder using the four
screws, turning them clockwise.
»
91