Seat Toledo 2019 Owner's Manual page 126

Fog lights*
Instrument panel: light panel.
Fig. 132
Switching on front fog lights
First turn the light switch
–
tion , or .
  
Pull on the light switch to position
–
The warning lamp lights up on the general

instrument panel if the front fog lights are
switched on.
Fog lights with cornering light func-
tion
3 Not available on vehicles equipped with full-
LED headlights and bulb fog lights.
The cornering light function is an additional
function to the dipped beam headlights to
improve lighting of the side of the road when
taking a sharp turn at low speed.
124
The cornering light function works when the
dipped beam headlights are already on and
it is enabled when driving at speeds below
approximately 40 km/h (25 mph).
Forward gear
If the steering wheel is turned to the right or
●
the right-hand turn signal switched on, the
right-hand fog lamp is gradually switched on.
If the steering wheel is turned to the left or
●
the left-hand turn signal switched on, the left-
hand fog lamp is gradually switched on.
After the turn, the cornering light function is
●
gradually switched off.
›››
Fig. 132 to posi-
Reverse gear
When engaging the reverse gear, both fog
●
.
1
lights turn on.
Rear fog light
Switching on the rear fog light
First turn the light switch
–
›››
page 124
Pull on the light switch to position
–
If the vehicle is not equipped with front fog
›››
lights
ed on by turning the switch to position
and pulling it to position

switch only has one position.
Operation
›››
Fig. 132
to position , or .
  
.
2
page 124, the rear fog light is switch-

. This type of
2
›››
The page 103 warning lamp lights up

on the general instrument panel if the rear
fog lights are switched on.
If you are towing a trailer or caravan equip-
ped with a rear fog light on a vehicle with a
factory-fitted towing bracket or one instal-
led using parts from the original SEAT
parts catalogue, only the rear fog light on
the trailer or caravan will light up.
Function "Coming Home"/"Leaving
Home"*
This function makes it possible, under poor
visibility conditions, to automatically turn on
the lights for a brief period of time after the
vehicle has been parked or when approach-
ing the vehicle.
The function is automatically turned on if
the following conditions are met:
The light switch is in position
●
›››
page 123.
The visibility around the vehicle is reduced.
●
The ignition is switched off.
●
To turn on this function, switch on the head-
light flasher prior to exiting the vehicle.
or
