Setting Levels - Viessmann VITOTRONIC 200 Service Instructions Manual

Introduction
Appliance types
(cont.)
Refrigerant circuit controller
Heat pump
Brine/water heat pumps
Vitocal 222-G
■
Vitocal 333-G
■
Air/water heat pumps for indoor installation,
monoblock version
Vitocal 200-A, type AWCI-AC 201.A
■
Air/water heat pumps for outdoor installation,
monoblock version
Vitocal 300-A, type AWO-AC 301.B
■
Vitocal 300-A, type AWO 302.B
■
Air/water heat pumps with indoor/outdoor units,
split version
Vitocal 100-S
■
Vitocal 111-S
■
Vitocal 200-S
■
Vitocal 222-S
■
Air/water heat pumps with indoor/outdoor units,
monoblock version
Vitocal 200-A, type AWO(-M)/AWO(-M)-E/
■
AWO(-M)-E-AC 201.A
Vitocal 222-A
■

Setting levels

To avoid incorrect operation of the heat pump and
other system components, not all menus are available
at every setting level. For example, control parameters
can only be called up at the contractor setting level.
System user
Operation takes place in the standard menu and in the
extended menu and is suitable for individuals who
have been trained in the operation of the heating sys-
tem by a heating contractor.
■ The general operating functions and displays are
found in the standard menu. For example, setting of
the room temperature set value or selection of the
operating program.
■ The extended menu offers further functions, such as
the setting of time programs, for example. To call up
the extended menu, press
Contractor
Additional functions and the parameters of
Coding level 1 are available at this setting level. These
functions and parameters are identified by the
bol.
24
Refrigerant circuit controller
[2]
X
.
sym-
!
[4] [4-3] [4-4] [4-6] [4-7]
X
X
X
X
X
X
For functions at the "System user" setting level,
see the operating instructions.
[6] [7] / [7-1]
X
X
X
X