Changing The Parameters - Siemens SENTRON ATC6300 Manual

If access is possible, the following window appears:
①
②
③
④
⑤
⑥
This window contains information on the range of values, the minimum and maximum
values, the previous setting, and the factory default setting.
9.1.1

Changing the parameters

● The parameters can be changed using the + and – keys.
● Pressing the + and – keys simultaneously leads to the factory setting.
● For a text string entry, the character is selected using the ▲ and ▼ keys and the cursor is
moved through the text using the + and – keys.
● By pressing ▲ and ▼ simultaneously in the case of a text entry, the character selection is
set to the letter A.
● By pressing the ✓ key, the currently selected parameter is stored.
The device then returns to the menu one level above this (in this case, to the P04 Battery
diagram).
● You can exit the setup menu by pressing OFF.
Note
Restart after parameter change
After each parameter change the device executes a restart. If it remains in the setup menu
for more than two minutes without any changes being made, the device will also restart.
After the restart, the ATC is in the OFF mode.
3KC ATC6300 transfer control device
Manual, 03/2018, L1V30535632002A-01
New value entered
Maximum possible setting
Factory default setting
Minimum possible setting
Parameter code
Parameter description
9.1 Parameterization via the user interface
Parameterization
117