Activating The Multiranger; Changing Parameters - Siemens MAG 1100 Operating Instructions Manual

Activating the MultiRanger

All the instructions in the following procedures apply to the hand programmer and
assume that the MultiRanger is activated.
1. Power the MultiRanger.
2. Point the programmer at the unit and press PROGRAM
3. Press DISPLAY
Power up display
Note:
• Single Point Model
• preset to display distance from the face of the transducer to the
material
• transducer selection is preset for the XPS-10
• empty distance is preset to 5m
• Dual Point Model
• starts in an OFF state and does not take level measurements
• to set up measurement, the quick start parameters must be
configured
• See Quick Start parameters on page 119

Changing Parameters

If Parameter Value alteration is not permitted, access the Lock parameter
Note:
(P000) and enter the security code, (see Security below).
1. Starting in RUN mode, press PROGRAM
unit into PROGRAM mode.
2. Press DISPLAY
3. Enter the Parameter Number (e.g. 110). After the third digit is entered, the parameter
value is shown.
4. Enter the new value, and press ENTER
either accepting or replacing it with a valid value.
Helpful Hints
• For parameters P001 to P009, press a single digit (1–9) and then press DISPLAY
to show that parameter.
• The ? icon indicates that the MultiRanger has accepted the value but that it conflicts
with other values entered. Double-check your programming.
• By default, the SCROLL arrows
any that have been changed.
• P733 sets all parameters to be scroll-accessed.
7ML19981FB05 MultiRanger 100/200 – INSTRUCTION MANUAL
.
to select the Parameter Number field.
show only the Quick Start parameters and
.
and then press DISPLAY
. The MultiRanger interprets the value,
to put the
Page 31