Switching Mymodes With The Cockpit App; Switching Mymodes Using Motion Patterns - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Use

9.2.1 Switching MyModes with the cockpit app

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by connecting/discon­
necting the battery charger. Bluetooth is then turned on for approx. 2 minutes. During this time, the app must be
started and used to establish a connection. If required, Bluetooth on the prosthesis can be switched on perman­
ently afterwards (see Page 69).
Once a connection to a prosthesis has been established, the cockpit app can be used to switch between the
MyModes.
Product
1. Basic Mode 2. Golf
1
2
3
100% 1. Basic Mode

9.2.2 Switching MyModes using motion patterns

Information on switching
• Switching and the number of motion patterns must be activated in the adjustment software.
• Before the first step, always check whether the selected mode corresponds to the required motion type.
Requirements for successful switching using motion patterns
The following points must be observed to carry out switching successfully:
• Switching using motion patterns has to be enabled in the adjustment software.
• Position the prosthetic leg back slightly (lunge position) and bounce on the forefoot while maintaining constant
contact with the floor.
Then keep the prosthetic leg still in this position (lunge position) for about 1 second without lifting the leg. Tak­
ing the weight off is no longer necessary.
Switching process
1) Position the prosthetic leg back slightly (lunge position).
2) While maintaining constant contact with the floor, bounce on the forefoot a number of times in one second
depending on the desired MyMode (MyMode 1 = 3 times, MyMode 2 = 4 times).
3) Keep the prosthetic leg still in this position (lunge position) for about 1 second without lifting the leg.
Taking the weight off is no longer necessary.
→ A beep signal will sound to confirm that the motion pattern has been recognised.
INFORMATION: If this beep signal does not sound, the requirements were not observed when
bouncing the foot.
4) Move the prosthetic leg in next to the contralateral leg, set it down and keep it still for approx. 1 second.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched to the corresponding
MyMode (2 times = MyMode 1, 3 times = MyMode 2).
INFORMATION: If this confirmation signal does not sound, the leg with the prosthesis was not cor­
rectly repositioned and kept still. Repeat the process to correctly switch to the required mode.
66 | Ottobock
1) Tap the symbol of the MyMode (1) you want in the main menu of the
app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the active mode.
→ The current mode is also indicated by the symbol and name on the
lower edge of the screen (3).
C-Leg 3C98-3/3C88-3