Initial Connection Between Cockpit App And Prosthesis; Starting The Cockpit App For The First Time; Control Elements For Cockpit App - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

8.2 Initial connection between cockpit app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of the foot must
point up) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth
on the prosthesis can be switched on permanently afterwards (see Page 69).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are turned off.
• The device must be connected to the internet.
• The serial number and PIN code of the component being connected must be known. They are found on the
enclosed card. The serial number begins with the letters "SN".

8.2.1 Starting the cockpit app for the first time

1) Tap the symbol.
→ The end user license agreement (EULA) is displayed.
2) Accept the end user license agreement (EULA) by tapping the Accept button. If the end user license agree­
ment (EULA) is not accepted, the cockpit app cannot be used.
→ The welcome screen appears.
3) Tap the Add component button.
→ The "Preparation" screen appears. The serial number of the component should be entered here.
4) Follow the subsequent instructions on the screen.
5) After the PIN code is entered, a connection to the prosthesis is established.
→ While the connection is being established, 3 beep signals sound and the
The symbol is displayed when the connection has been established.
→ Once the connection has been established successfully, the data are read from the prosthesis. This process
may take up to a minute.
The main menu will then appear with the name of the connected prosthesis.
INFORMATION
After the initial connection to the prosthesis has been established successfully, the app will connect automatically
each time it is started. No further steps are required.

8.3 Control elements for cockpit app

1
Product
2
1. Basic Mode 2. Golf
4
5
6
100% 1. Basic Mode
C-Leg 3C98-3/3C88-3
1. Call up the navigation menu (see Page 62)
2. Product
The component name can only be changed with the adjustment soft­
change
ware.
3
3. If connections to more than one component have been saved, you can
switch between the saved components by tapping the entry change.
4. MyModes configured with the adjustment software.
Switching the mode by tapping the corresponding symbol and confirm­
ing by tapping "OK".
5. Currently selected mode
6. Charge level of the component.
Component battery fully charged
Component battery empty
The current charge level is also displayed in %.
7
Display and name of the currently selected mode (e.g. 1. Basic
7.
Mode)
8
8. Connection to component has been established
Connection to component has been interrupted. The app is attempt­
ing to re-establish the connection automatically.
Cockpit app
symbol appears.
Ottobock | 61