Mymodes; Switching Mymodes With The Cockpit App - Otto Bock Genium Instructions For Use Manual

MyModes

switch from stance to swing. Because DSC is always monitoring knee function, multi-directional movement and
walking backward are also possible without risk of stance resistance releasing.
Adaptive swing phase control
Instantaneous adaptation to varied walking cadences and to changes of the pendular mass (e.g. varying footgear)
ensures the knee always achieves the swing flexion target angle within (+/-) one degree. The swing phase exten­
sion and flexion resistance experienced by the user are auto-adaptive.
The flexed and partially loaded knee will also disable the stance phase on slopes and ramps to allow for greater
knee flexion and more ground clearance in the swing phase.
10 MyModes
In addition to basic mode (mode 1), up to 5 MyModes can be activated and configured with the adjustment soft­
ware. They can be called up by the patient using the Cockpit app. Only the first 3 MyModes can be selected using
movement patterns. Switching by using movement patterns has to be activated in the adjustment software.
These modes are intended for specific motion patterns or postures (e.g. inline skating, running (jogging) ...).
Default settings for these motion patterns and postures can be called up and individually adapted using the adjust­
ment software.
Settings can also be adjusted by the patient using the Cockpit app (see Page 87).

10.1 Switching MyModes with the cockpit app

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function only available in
basic mode) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth on
the prosthesis can be switched on permanently afterwards (see Page 88).
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app (see Page 85) or if mute mode (silent mode) is activated,
there are no beep signals.
Once a connection to a prosthesis has been established, the cockpit app can be used to switch between the
MyModes.
90 Genium 3B1-3/3B1-3=ST