Check after 10 minutes of driving
›››
Screw the inflator tube
Fig. 33
and check the pressure on the gauge
1.3 bar (19 psi / 130 kPa) and lower:
Stop the vehicle! The tyre cannot be
●
sealed sufficiently with the tyre mobility set.
You should obtain professional assistance
●
›››
.
1.4 bar (20 psi / 140 kPa) and higher:
Set the tyre pressure to the correct value
●
again.
Carefully resume your journey until you
●
reach the nearest specialised workshop with-
out exceeding 80 km/h (50 mph).
Have the damaged tyre replaced.
●
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious in-
jury.
Do not continue driving if the tyre pres-
●
sure is 1.3 bar (19 psi / 130 kPa) and lower.
Seek specialist assistance.
●
Changing a wheel
again
5
Related video
.
6
What to do first
Park the vehicle on a horizontal surface and
●
in a safe place as far away from traffic as
possible.
Apply the electronic parking brake.
●
Switch on the hazard warning lights.
●
Manual transmission: select the 1st gear.
●
Automatic transmission: Move the selector
●
lever to position P.
If you are towing a trailer, unhitch it from
●
your vehicle.
Have the vehicle tool kit
●
the spare wheel* ready
Observe the applicable legislation for each
●
country (reflective vest, warning triangles,
etc.).
Self-help
Wheels
Fig. 34
›››
page 38
and
›››
page
355.
All occupants should leave the vehicle and
●
wait in a safe place (for instance behind the
roadside crash barrier).
WARNING
Always observe the above steps and pro-
●
tect yourself and other road users.
If you change the wheel on a slope, block
●
the wheel on the opposite side of the car
with a stone or similar to prevent the vehi-
cle from moving.
Integral wheel trim
Remove the wheel cover.
Fig. 35
The wheel covers must be removed for ac-
cess to the wheel nuts.
Removing
Take the wheel brace and the wire hook
●
›››
from the vehicle tool kit
page
»
38.
41