Seat LEON 2019 Owner's Manual page 253

Table of Contents

Advertisement

leaving the vehicle, otherwise the battery
could discharge.
If the engine has been driven at high
speed for a prolonged period of time, it
may overheat when turned off. To avoid en-
gine damage, allow the engine to run for
approximately two minutes in neutral be-
fore switching it off.
Note
After the engine is switched off the radiator
fan may run on for up to 10 minutes, even if
the ignition is switched off. It is also possi-
ble that the fan turns itself on once more if
the coolant temperature increases due to
the heat accumulated in the engine com-
partment or due to its prolonged exposure
to solar radiation.
Electronic immobilizer
The electronic immobiliser prevents unau-
thorised persons from driving the vehicle.
Inside the key there is a chip that deactivates
the electronic immobiliser automatically
when the key is inserted into the ignition.
The electronic immobiliser will be activated
again automatically as soon as you pull the
key out of the ignition lock. For vehicles with
the "Keyless Access" system, the key has to
be outside the vehicle.
Start and driving
If the following message is shown on the in-
strument panel display: SAFE , the vehicle
cannot be started.
The engine can only be started using a genu-
ine SEAT key with its correct code.
Note
A perfect operation of the vehicle is ensur-
ed if genuine SEAT keys are used.
Emergency starting function
On the right of the steering column:
Fig. 256
emergency start.
If no valid key is detected inside the vehicle,
an emergency start-up will be required. The
relevant message will appear in the dash
panel display. This may happen when, for ex-
ample, the vehicle key battery is very low:
Immediately after pushing the starter but-
ton, keep the key next to the right trim of the
›››
steering column
Fig.
256, as close as pos-
sible to the Kessy logo.
The ignition connects and the engine starts
automatically.
Instructions for the driver on the in-
strument panel display
Press the clutch
This message appears on vehicles with a
manual gearbox if the driver tries to start the
engine without having the clutch pedal
pressed. The engine will only start if you press
the clutch pedal.
Press the brake
This message appears on vehicles with an
automatic gearbox if the driver tries to start
the engine without having the brake pedal
pressed.
Select N or P
This message appears if you try to start or
stop the engine when the selector lever of the
automatic gearbox is not in position P or N.
The engine can only be started and stopped
in those positions.
»
251

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents