Fitting the tow hook
Putting the tow hook in place. Step 1.
Fig. 301
318
Driving
Putting the tow hook in place. Step 2.
Fig. 302
Step 1.
Remove the hook housing cap
●
downwards.
4
Put the tow hook in its standby position
●
›››
page
317.
Hold the tow hook from below and fit it into
●
the hook hosing in the direction of the arrow
›››
Fig. 301
until it is heard to fit into place
1
›››
.
›››
Lever
Fig. 301
the direction of arrow
lease bolt
moves outwards (its red and
B
green parts are visible)
If lever
does not turn or the release bolt
A
does not come out, the tow hook should be
removed by turning the lever as far as possi-
ble downwards from the housing cavity, and
the tow hook's support surfaces and the cavi-
ty should then be cleaned.
Step 2.
Turn the key to the right just half a turn, until
●
the hole in the key faces downwards
›››
Fig. 302
1
Remove the key
●
Place the cover
●
›››
›››
Fig. 302
Check that the tow hook is correctly fixed in
●
›››
place
page 319, Safety
WARNING
›››
Fig. 298
Keep your hands away from the lever
●
when fitting the tow hook to avoid trapping
›››
your fingers
Do not try to force the lever up to turn the
●
key. The detachable ball would not be se-
cured properly!
automatically turns in
A
upwards, and the re-
2
›››
.
B
.
.
2
on the lock
B
3
.
check.
Fig. 301
.
A