If the brake pedal is pressed.
●
If the airbag is triggered.
●
If the lever is taken out of the D/S position.
●
WARNING
Use of GRA could cause accidents and se-
vere injuries if it is not possible to drive at a
constant speed maintaining the safety dis-
tance.
Do not use GRA in heavy traffic, if the dis-
●
tance from the vehicle in front is insuffi-
cient, on steep roads, with several bends or
in slippery circumstances or on flooded
roads.
Never use the CCS when driving off-road
●
or on unpaved roads.
Adapt your speed and the distance to the
●
vehicles ahead in line with visibility, weath-
er, the condition of the road and the traffic
situation.
To avoid unexpected operation of the
●
cruise control system, turn it off every time
you finish using it.
It is dangerous to use a set speed which is
●
too high for other conditions.
If driving down a steep gradient, the GRA
●
cannot maintain a constant speed. The
speed can increase. In this case, brake and
change down a gear.
272
Driving
Operating the cruise control
On the turn signal lever: controls for
Fig. 268
operating the GRA.
Connecting
›››
Move the control
Fig. 268
●
If no speed has been programmed, the sys-
tem will not control it.
Activating the cruise control
›››
Press button
Fig. 268
in area
●
2
The current speed is stored and the cruise
control is activated.
Temporarily interrupting
›››
Move the control
Fig. 268
●
step on the brake.
The cruise control system is switched off tem-
porarily. The speed is stored.
Reinstating the cruise control
Press button
●
Cruise control is activated at the stored
speed.
Adjusting the speed
While the GRA is set, the stored speed can be
adjusted with button
To increase in increments of 1 km/h (1 mph)
●
briefly press button
.
To increase the speed without interruption,
●
›››
keep button
the area
to
.
1
To reduce in increments of 1 km/h (1 mph)
●
briefly press button
.
To reduce the speed without interruption,
●
›››
keep button
the area
.
The vehicle adapts the current speed by ac-
celerating or stopping accelerating. The vehi-
cle does not brake actively.
Switching off
to
or
1
Move control
●
The system is disconnected and the memo-
rised speed is deleted.
›››
Fig. 268
in area
.
2
›››
Fig. 268
:
2
›››
Fig. 268
in the area
2
Fig. 268
pressed down in
2
.
›››
Fig. 268
in the area
2
Fig. 268
pressed down in
2
.
›››
Fig. 268
to
.
1