Rear towline anchorage
On the right side of the rear bumper:
Fig. 49
remove the cover.
Right side of the rear bumper: towline
Fig. 50
anchorage in position.
The housing of the screw towing eye is on the
right side of the rear bumper behind a lid
›››
Fig.
49.
Vehicles equipped as standard with a towing
bracket do not have any housing for the
Self-help
screw towing eye behind the lid. In this case,
the tow hitch needs to be extracted or instal-
›››
led and used for towing
page
Bear in mind the instructions for towing
›››
page
50.
Assemble the rear towing eye (cars with-
out a factory-equipped towing bracket)
Remove the towing eye from the vehicle
●
tool kit in the luggage compartment
›››
page
38.
Press the top right hand side of the cover
●
›››
Fig. 49
to unclip it.
Remove the lid and let it hang from the ve-
●
hicle.
Screw the towline anchorage into the hous-
●
ing by turning it as far as it will go anticlock-
›››
›››
wise
Fig. 50
. Use a suitable object
that can completely and securely tighten the
towing eye in its housing.
After towing, unscrew the towing eye
●
clockwise with a suitable object.
Clean the towing eye if necessary and then
●
store it in the luggage compartment along
with the other vehicle tools.
CAUTION
The towing eye must always be com-
●
pletely and firmly tightened. Otherwise, it
could be released while towing and tow-
starting.
If the vehicle is factory-equipped with a
●
towing bracket, it is only allowed to tow
›››
309,
.
with a tow bar if this has been specially de-
signed to be installed with a tow hitch. If an
unsuitable tow bar is used, both the tow
hitch and the vehicle may be damaged. In-
stead, a tow rope should be used.
53