Seat LEON 2019 Owner's Manual page 256

The interior temperature differs from the
●
temperature selected on the climate control.
Defrost function button activated
●
›››
page 155.
The brake has been pressed several times
●
consecutively.
The battery is too low.
●
High power consumption.
●
Additional information related to the auto-
matic gearbox
The engine stops when the selector lever is in
the positions P, D, N and S
when in Tiptronic mode. With the selector lev-
er in P, the engine will also remain switched
off when you take your foot off the brake
pedal. In order to start the engine up again
the accelerator must be pressed, or another
gear engaged or the brake released.
If the selector lever is placed in R while stop-
ped, the engine will start up again.
Change from D to P to prevent the engine
from accidentally starting when passing
through R.
1)
Except in the CUPRA model. In this case, when
you place the selector lever in the S position or in
the Tiptronic mode, the Start/Stop system will
prevent the engine from switching off.
254
Additional information about vehicles with
Adaptive Cruise Control (ACC)
In vehicles with ACC function, the engine will
start up again in certain operating conditions
if the radar sensor detects that the vehicle
ahead drives off again.
WARNING
Never switch the engine off until the vehi-
●
cle is stationary. The operation of the brake
and steering will not be fully guaranteed.
More force will be needed to turn the steer-
ing wheel or to brake. You could suffer an
accident and even serious injuries.
1) in addition to
To avoid injury, make sure that the Start-
●
Stop system is switched off when working
in the engine compartment
CAUTION
The Start-Stop system must always be
switched off when driving through flooded
›››
areas
Note
In vehicles with an automatic gearbox,
●
you can control whether the engine should
switch off or not by reducing or increasing
Driving
›››
page 255.
page 270.
the brake force applied. While the vehicle
remains stopped, the engine will not stop if
the brake pedal is slightly pressed, in traffic
jams with frequent stopping and starting
for example. As soon as strong pressure is
applied to the brake pedal, the engine will
stop.
When stopped, the brake pedal must be
●
kept pressed to ensure that the vehicle
does not move.
If the engine "stalls" with a manual gear-
●
box, it can be directly started up again by
immediately pressing the clutch pedal.
With an automatic gearbox, if the lever is
●
placed in position D, N or S after engaging
reverse gear, 10 km/h (6 mph) in a forwards
direction must be reached for the system to
be in a status to stop the engine.