Seat LEON 2019 Owner's Manual page 107

Unlocking and opening the doors
(Keyless-Entry)
Grip one of the front door handles. When
●
you do this, you touch the sensor surface
›››
Fig. 100 (arrow) of the handle and the
A
vehicle unlocks.
Open the door.
●
On vehicles with selective opening or info-
tainment system configuration, pulling the
door handle twice will unlock all doors.
In vehicles without the "Safe" security sys-
tem: closing and locking the doors
(Keyless-Exit)
Switch the ignition off.
●
Close the driver's door.
●
Touch (once) the locking sensor surface
●
›››
Fig. 100 (arrow) on one of the front
B
door handles. The door that is used must be
closed.
In vehicles with the "Safe" security sys-
tem: closing and locking the doors
(Keyless-Exit)
Switch the ignition off.
●
Close the driver's door.
●
Touch (once) the sensor surface
●
(arrow) on one of the front door handles.
B
The vehicle locks with the "Safe" security sys-
›››
tem page 106. The door that is used must
be closed.
Opening and closing
Touch (twice) the sensor surface
●
›››
Fig. 100 (arrow) of one of the front door
B
handles to lock the vehicle without activating
the "Safelock" security system
Unlocking and locking the boot hatch
When the vehicle is locked, the rear lid auto-
matically unlocks on opening if there is a val-
id vehicle key in the proximity
Open or close the rear lid normally.
After closing, the hatch locks automatically. If
the complete vehicle is unlocked, the rear lid
will not lock automatically after closing it.
What happens when locking the vehicle
with a second key
If there is a vehicle key inside the vehicle and
it is locked from the outside with a second ve-
hicle key, the key inside the vehicle is blocked
for engine ignition
enable engine ignition, press the
the key inside the vehicle.
Automatically disabling sensors
If the vehicle is not locked or unlocked for a
long period of time, the proximity sensors on
the passenger doors are automatically disa-
bled.
›››
Fig. 100
If one of the sensor surfaces on the door han-
dles is often activated in an unusual manner
with the vehicle locked (e.g. by the branches
›››
page 106.
›››
Fig. 99.
›››
page 247. In order to
button on

of a bush rubbing against it), all proximity
sensors are disabled for a certain period of
time.
Sensors will again be enabled:
After a time.
●
OR: if the vehicle is unlocked with the but-
●
ton on the key.

OR: if the boot is opened.
●
OR: if the vehicle is unlocked manually with
●
the key.
Keyless Access temporary disconnection
function*
You can deactivate the vehicle's Keyless
Access unlocking for one locking and unlock-
ing cycle.
Move the gear lever to position P (if the ve-
●
hicle has automatic gearbox), since other-
wise the vehicle cannot be locked.
Close the door.
●
Push the central locking button
●
mote control and touch the locking sensor
surface of the driver door handle
›››
Fig. 100 within the following 5 seconds.
B
Do not grasp the door handle; otherwise the
vehicle will not unlock. Deactivation is also
possible if the vehicle is locked through the
driver's door lock.
To check that the function has been deacti-
●
vated, wait at least 10 seconds, grip and pull
on the re-

»
105